Our K-series industrial battery chargers are designed with SCR thyristor switching technology to generate a correct voltage level for the control in the direct current output, which is adjusted by a phase control through a microprocessor. It allows the interaction between the flotation charge and the equalization of acid lead or nickel-cadmium batteries.

The design of the enclosure is determined according to the characteristics of the K-series industrial charger required by our clients.

• Output voltage range of 120 VDC
• Enclosure to wall or floor
• Enclosure with NEMA 3 standard to NEMA 12
• Indoor or Outdoor Enclosure
• Battery bank included

• Voltage ranges: float and equalization (Independent and adjustable)
• Input voltage: 220-440, 240-480 3-wire and neutral
• Output voltage: nominal 2, 24, 48, 130 and 260 VDC
• Current range: 6-400 Amps. with current limit
• Frequency: 60 HZ +/-5%
• Adjustment range: +/- 0.25%
• Temperature: 0° to 50°C
• Operating altitude: 2,500 meters above sea level
• Electrical noise: maximum 1% RMS with a battery capacity 4 times > than rated current, typical 205% RMS without battery and 32
• Audible noise: 60db at 1.5 meters distance
• Input and output voltmeter: available
• User interaction: has display and keypad to verify and adjust parameters.
• Special designs for single-phase industrial chargers.